How to prevent the air cushion film bag making machine? In order to make the air cushion film bag making machine work more efficiently, we must do the corresponding preventive work before using the air cushion film bag making machine to avoid equipment failure and cannot continue to operate. Affecting production efficiency, let's take a look at it together!

       The air cushion film produced by the air cushion film bag making machine can effectively protect the product, so it has been widely used in many industries. Because the air cushion film has good performance, it can provide good protection for various products, and high-quality air cushionThe film is often made by the bubble film bag making machine. How to solve the failure in the production process? How can we do the preventive work? The air cushion film bag making machine should be assigned a special person to operate, and it is not allowed to squeeze The discharge screw runs idly when there is no material to prevent the screw and the barrel from being scratched. After shutdown, if there is material stored in the barrel, before restarting the machine, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the temperature must be kept for more than 30 minutes before starting. It is strictly forbidden to start the machine before the temperature reaches the requirements. so as not to damage the parts. When the air cushion film machine is feeding the hopper, it must be kept clean, and the metal sundries, sand, gravel and small tools must be strictly prevented from entering the material port to prevent damage to the barrel and screw. If abnormal noise is found during operation, it should be stopped immediately for processing. In order to avoid this kind of failure, it is very important for us to do a good job in the maintenance of the bubble film bag making machine. The screw of the air-cushion film machine is taken out of the barrel for some reason and should be handled properly to prevent deformation. If it is not put back into the barrel for a long time, the screw must be hung vertically to prevent bumps, bending and permanent deformation. The barrel and screw surfaces are coated with anti-rust oil for protection. After the bubble film bag making machine is stopped, if there is material stored in the barrel, before starting the machine again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the temperature must be kept for more than 30 minutes before starting the machine. Turn on the machine before meeting the requirements to avoid damage to the parts. The air cushion film bag making machine is regularly inspected, the die head is thoroughly cleaned every three months, the various bearings are replaced with grease, the reducer is replaced with lubricating oil every six months, and the overall equipment is overhauled every two years.

       The above is the introduction of the preventive work of the air cushion film bag making machine.